CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-82
8.10.58 LEFT MARGIN SET COMMAND [GS] L
Function Sets the left margin as specified by nL and nH.
The left margin is determined by [(nL + nH × 256) × dots].
Format [GS] LnLnH
Term ASCII: GS L
Hex: 1Dh 4Ch
[Parameter]
nL: Width of print area 0 ≤ nL ≤ 255 (00h ≤ nL ≤ FFh)
nH: Width of print area 0 ≤ nH ≤ 255 (00h ≤ nH ≤ FFh)
Default value nL = 0, nH = 0
Explanation (1) This command will be valid only if received at the beginning of a line.
(2) If this command is received while the printer is in page mode, the defined parameter
setting will be applied after switching to standard mode.
(3) The command settings do not have any impacts upon page mode.
(4) The maximum permissible left margin is equal to the width of the printable area. If
a specified value exceeds the maximum value, it will be rounded to the maximum
value.
Reference Print Area Width Set Command ([GS] W)
Printable area
Left margin Width of print area
To Next Page
Loading...
Need help?
General