CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-35
10.11 SETUP MODE
10.11.1 GENERAL DESCRIPTION
The settings can be changed not only by commands but also by the key operations from the
printer. This section describes how to change the settings by the key operations from the
printer.
10.11.2 HOW TO ENTER INTO SETUP MODE
The [POWER] key is pressed while holding down the [FEED] or [PAUSE] key.
10.11.3 AUTO POWER-OFF FUNCTION DURING SETTING
Not performed.
10.11.4 HOW TO CHECK EACH SETUP MODE
Setup mode check is conducted by printing self-test results.
* For details, refer to the Key Operation Specification.
10.11.5 OTHER
The printer does not enter into the power save mode during the setup mode.
If the setting is the same as before, it is not written into flash ROM.
Settings made take effect, after the printer is turned OFF then ON by pressing the [POWER] key
in the SYSTEM mode, or when the printer is restarted by the Reset Command.
To Next Page
Loading...
Need help?
General