CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-58
8.10.40 CHINESE CHARACTER SPACING SET COMMAND [FS] S
Function Specifies spacing (or the number of dots) on both sides of a Chinese character.
Format [FS] Sn1n2
Term ASCII: FS S
Hex: 1Ch 53h
[Parameter]
n1: Spacing on the left of Chinese character 0 ≤ n1 ≤ 99 (00h ≤ n1 ≤ 63h)
n2: Spacing on the right of Chinese character 0 ≤ n2 ≤ 99 (00h ≤ n2 ≤ 63h)
Default value n1: 0, n2: 0
Explanation (1) Spacing defined this command is the one when a character size is standard. If a
character with a magnification of x 2 or over in the horizontal direction is expanded,
spacing will be determined by the specified spacing × magnification in the horizontal
direction.
(2) A sum of spacing on both sides of a character must never exceed 99. If so, it will
be changed to 99.
(3) Spacing can be independently specified in page and standard modes.
(4) If a double-width character is specified, spacing will also be doubled.
(5) For the B-EP series, spacing on the left of a Chinese character is added to spacing
on its right. Therefore, there is no space found on the left of the Chinese character
in the print output.
To Next Page
Loading...
Need help?
General