CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-189
5.12 COMMANDS RELATED TO PC COMMAND SAVING
5.12.1 SAVE START COMMAND [ESC] XO
Function Declares the start of saving PC interface commands.
(Places the printer in the mode where PC interface commands are written in the flash
memory.)
Format [ESC] XO; aa, (Sb, ) c [LF] [NUL]
Term aa: Identification number to be used for saving in flash memory or reading
01 to 99
Sb: Reserved area (Omissible)
b: 0 to 2
c: Status response at save time
0: No status response
1: Status response is returned
Notes
(1) After sending the Save Start Command ([ESC] XO), any command other than the
following will be saved into flash memory without being analyzed.
• Save Start Command ([ESC] XO)
• Save Terminate Command ([ESC] XP)
• Saved Data Read Command ([ESC] XQ)
• Bit Map Writable Character Command ([ESC] XD)
• Reset Command ([ESC] WR)
• Status Request Command ([ESC] WS, [ESC] FM, [ESC] v)
• Flash Memory Format Command ([ESC] J1)
• Mode Information Acquire Command ([ESC] WX)
• Version Information Acquire Command ([ESC] WV)
• Bluetooth Device Address Acquire Command ([ESC] IT)
• Strip Sensor Adjust Command ([ESC] AH)
• Printer ID Set Command ([ESC] ID)
• Mode Select Command ([ESC] M)
(2) No error check is made for the commands when saving them.
(3) Up to 64 KB can be saved per a save.
(4) The status response when saving the commands is not returned when they end normally
but only when an error occurs.
Refer to • Save Terminate Command ([ESC] XP)
• Flash Memory Format Command ([ESC] J1)
To Next Page
Loading...
Need help?
General