CHAPTER 5 TPCL MODE (INTERFACE COMMANDS)
B-EP Series
5-24
5.5.2 CLEAR AREA COMMAND [ESC] XR
Function Clears the designated area or reverses the white/black dot pattern in the designated
area in the drawing area.
Format [ESC] XR; aaaa, bbbb, cccc, dddd, e [LF] [NUL]
Term aaaa: X-coordinate of the designated area start point
Fixed at 4 digits (in 0.1 mm units)
bbbb: Y-coordinate of the designated area start point
4 or 5 digits (in 0.1 mm units)
cccc: X-coordinate of the designated area end point
Fixed at 4 digits (in 0.1 mm units)
dddd: Y-coordinate of the designated area end point
4 or 5 digits (in 0.1 mm units)
e: Type of how to clear
A: Clears the contents in the designated area to zeros.
B: Reverses the white/black dot pattern in the designated area.
Explanation
Label
Paper feed direction
0
X
Y
Effective
print length
Effective
print width
Start point
End point
Origin of
coordinates
(0, 0)
Backing paper
To Next Page
Loading...
Need help?
General