CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-43
7.10 COMMANDS RELATED TO STATUS
7.10.1 STATUS REQUEST COMMAND [ESC] v, [ [ESC] FM, [ESC] WS
Function Requests that the printer sends back the printer status and the battery status to the
host.
Format [ESC] v, [ESC] FM [LF] [NUL], or [ESC] WS [LF] [NUL]
Explanation When this command is received, the printer sends the printer status and battery status
to the host.
• For IrDA: TEC Protocol: Data to be sent (Fixed at 27 bytes)
STX Printer ID Version No. of each form Printer status Battery status CRC
02H xxH xxH V01 V02 ········· V20 xxH xxH xxH xxH
• For IrDA; IrCOMM, IrDA: IrOBEX, RS-232C, USB, Bluetooth or Wireless LAN:
Data to be sent (Fixed at 5 bytes)
STX Printer ID Printer status Battery status
02H xxH xxH xxH xxH
Printer ID ............... 2-byte hex data (in order from High to Low)
Printer status ......... Printer status is indicated in 1-byte data.
00H: Normal status (while idling)
01H: Cover open status
02H: Command syntax error (including Ir packet error)
03H: Paper jam
04H: Label end
05H: Cover open error
06H: Broken thermal head dots error
07H: Thermal head excessive temperature
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH: Operating
0CH: Communication error ....... For RS-232C connection only
0DH: Normal end + Label end (See NOTE.)
0EH: Flash ROM storage area full state
10H: Normal issue end
14H: Pause state
19H: Ambient temperature error
32H: Abnormal battery temperature
33H: Battery excessive temperature
37H: Charging error
(38H: Bluetooth setting successfully completed)
Response status for automatic status transmission
39H: Bluetooth setup error (including initialization error)
45H: Wait for battery recovery
46H: Wait for print head temperature reduction
47H: Wait for motor temperature reduction
55H: Writable character/PC command save mode
To Next Page
Loading...
Need help?
General