CHAPTER 9 ERROR PROCESSING
B-EP Series
9-5
9.3.2 BROKEN HEAD DOTS ERROR
c If broken head dots are detected in the broken head dots check when turning the power on
or closing the cover, an error will occur.
d If the thermal head driver fails, an error will occur.
9.3.3 THERMAL HEAD EXCESSIVE TEMPERATURE
c If the thermistor detects an excessively high temperature of 71 °C or higher, an error will
occur.
9.3.4 COVER OPEN ERROR
c If the cover open state is detected for 5 mm continuously while printing or feeding, an error will
occur.
d When printing is attempted with the cover opened, an error will occur.
* At the moment an error occurs, the printer displays an error message, and returns a status
response before it stops. Any commands except for the Status Request Command and the
Reset Command are not processed. The [PAUSE] key can be used for resetting except in
case where a thermal head excessive temperature error occurs. (The printer resumes printing
the label at which the error had occurred.)
To Next Page
Loading...
Need help?
General