CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-23
7.5.9 SECURITY LEVEL COMMAND [GS] s
Function Sets the security level.
Format [GS] sn
Initial value n: 00H
Term n: Security level to be set
00: Level 0
01: Level 1
02: Level 2
03: Level 3
04: Level 4
05: Level 5
06: Level 6
07: Level 7
08: Level 8
Explanation (1) When “n” is set to any value other than the above, a command error occurs.
(2) This command is effective for the PDF417 only. If this command is send for
printing other barcode/two-dimensional codes, the command will be ignored.
Refer to Barcode/Two-Dimensional Code Print Command ([GS] k)
To Next Page
Loading...
Need help?
General