CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-93
5.6.6 BARCODE FORMAT COMMAND [ESC] XB
~ In the case of GS1 Databar
Format c [ESC] XBaa; bbbb, cccc, d, e, ff, g, hhhh (, ijjjjjjjjjj, kk) (= sss ------ sss) [LF] [NUL]
d [ESC] XBaa; bbbb, cccc, d, e, ff, g, hhhh (, ijjjjjjjjjj, kk) (; tt
1
, tt
2
, tt
3
, ------, tt
20
) [LF]
[NUL]
Term aa: Barcode number
00 to 31
bbbb: X-coordinate of the print origin of barcode
Fixed at 4 digits (in 0.1 mm units)
cccc: Y-coordinate of the print origin of barcode
4 or 5 digits (in 0.1 mm units)
d: Type of barcode
b: GS1 Databar family
e: Version (Type of GS1 Databer)
1: GS1 Databar Omni-directional
2: GS1 Databar Stacked
3: GS1 Databar Stacked Omni-directional
4: GS1 Databar Limited
5: GS1 Databar Expanded
6: GS1 Databar Expanded Stacked
ff: 1-module width
01 to 15 (in units of dots)
g: Rotational angle of barcode
0: 0°
1: 90°
2: 180°
3: 270°
hhhh: Height of the barcode
0000 to 1000 (in 0.1 mm units)
ijjjjjjjjjj: Increment/decrement
(Omissible. If omitted, increment/decrement is not performed.)
i: Indicates whether to increment or decrement
+: Increment
-: Decrement
jjjjjjjjjj: Skip value
0000000000 to 9999999999
kk: No. of digits after zero suppression
(Omissible. If omitted, zero suppression is not performed.)
00 to 20
* Reserved in the case of the compatible mode for the B-SP series
To Next Page
Loading...
Need help?
General