CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-43
4.4 RECEIPT MODE
4.4.1 INITIAL SETTING
NOTES: (1) To store the writable character data, the mode should be changed to the LABEL
mode. After storing is finished, the mode should be returned to the RECEIPT
mode.
(2) When a command such as the above is sent, be sure to confirm that the process
is completed, before the next command is sent.
(3) The graphic data store command is registerable even after changing the mode to
the RECEIPT mode.
[ESC] M: Changes the mode to the RECEIPT mode.
Start
End
<Completion of mode selection>
[ESC] M: Changes the mode to the LABEL mode.
Mode Select Command
[ESC] XD: Stores the writable character data.
[ESC] SG: Stores the graphic data.
Writable Character Data Store Command
No
Yes
< Completion of storing >
No
Yes
< Completion of mode selection >
Mode Select Command
No
Yes
Graphic Data Store Command
< Completion of storing >
No
Yes
To Next Page
Loading...
Need help?
General