CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-51
8.10.35 CHINESE CHARACTER MODE SET COMMAND [FS] &
Function Prints Chinese characters.
Format [FS] &
Term ASCII: FS&
Hex: 1Ch 26h
Explanation (1) If this command is received with shift JIS selected for a Chinese character code
system, the defined parameter setting will be applied when the Chinese character
code system is changed to JIS. There is no impact upon printing.
(2) Chinese character mode is canceled by default.
(3) A Chinese character code is processed from the 1st to the 2nd byte.
(4) The parameter setting applies to the Chinese language settings with Chinese
language implemented for the QM model (destined overseas), or to the Korean
language setting with Korean language implemented.
Reference Chinese Character Mode Cancel Command ([FS] .)
Chinese Character Code System Set Command ([FS] C)
To Next Page
Loading...
Need help?
General