CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP Series
6-25
6.5.3 OUTLINE FONT FIELD COMMAND [ESC] PV
Function Sets the format to indicate the position on the label, at which the outline font is to be
printed and how it is to be printed.
Format [ESC] PVaa; bbbb, cccc, dddd, eeee, f, (,ghh), ii, j, kk, l, m, (,Pn) (,Qoooo,Rppp) [LF]
[NUL]
Term aa: Character string No.
00 to 99
(The same No. must not be used in one form for the bit map font field, the
outline font field, and the barcode/two-dimensional code field.)
bbbb: Print origin of X-coordinate of character string
Fixed at 4 digits (in 0.1 mm units)
cccc: Print origin of Y-coordinate of character string
Fixed at 4 digits (in 0.1 mm units)
dddd: Character width
0020 to 0300 (in units of 0.1 mm)
eeee Character height
0020 to 0300 (in units of 0.1 mm)
f: Type of font
A: TEC Font 1 (Helvetica [Bold])
B: TEC Font 1 (Helvetica [Bold], Proportional)
F: Price Font 2
K: Reserved
C, D, E: Reserved (If specified, it is processed as “B.”)
ghh: Character-to-character space width (Omissible. If omitted, the character-to-
character space width depends on the designated font.)
g: +, -
hh: 00 to 99 (dot)
ii: Rotational angles of a character and character string
00: 0° (chara.) 0° (chara.-string)
01: 90° (chara.) 90° (chara.-string)
02: 180° (chara.) 180° (chara.-string)
03: 270° (chara.) 270° (chara.-string)
j: Selects black character or reverse character
B (Fixed value): Black character
kk: Data length
00 to 99 NOTE: When “00” is designated, the length is equivalent to the
data sent by the Data Print Command.
JIS8 code: Data which is delimited by [LF]
Packed BCD code: Data which is delimited by “F”
l: Data code
1: JIS8 code
2: Packed BCD code (only for IrDA: TEC Protocol)
m: Fixed data No.
0 (Fixed value)
To Next Page
Loading...
Need help?
General