CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-31
10.10.7 SECURITY SETTING COMMAND [ESC] BS
Function Performs the security setting for the Bluetooth.
Format [ESC] BS; a [LF] [NUL]
Term a: Security setting
1: No security (Factory defalut setting)
2: Reserved.
3: Link level security
Explanation (1) In the LABEL mode (Mode = 0), RECEIPT mode (Mode = 1) or RECEIPT1 mode
(Mode = 2), the printer returns “38H” (setting completed) when the processing for
the Bluetooth module is completed successfully, and returns “39H” (setting error)
when failed. In the TPCL mode (Mode = A) or TPCL1 mode (Mode = B), the
printer returns “38” (setting completed) when the setting for the Bluetooth module
is completed, and returns “39” (setting error) when failed.
(2) In the system mode, “No security” is designated regardless of this security setting.
In addition, Bluetooth connection is not enabled on the B-EP-GH32 in the system
mode.
(3) This setting becomes effective when the printer is restarted after the parameter is
set and the printer power is turned off properly.
(4) When “2: Reserved” is specified, the Bluetooth module functions without security.
(5) Security setting and bonding
B-EP-GH30/TH30:
The Bluetooth module functions as follows regardless of the Bluetooth version of
the host.
Bonding setting Security setting Operation
Unregistered None Functions without a PIN code.
Unregistered Link level security Not connectable.
Registered None Functions without a PIN code.
Registered Link level security Functions with a PIN code.
To Next Page
Loading...
Need help?
General