CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-63
8.10.44 ID TRANSMISSION COMMAND [GS] I
Function Transmits the following ID specified by n.
Format [GS] In
Term ASCII: GS I
Hex: 1Dh 49h
[Parameter]
n: Selecting ID to transmit 1 ≤ n ≤ 3 (01h ≤ n ≤ 03h)
or
49 ≤ n ≤ 51 (31h ≤ n ≤ 33h)
n ID type ID to transmit
1 Model ID 0CH (12)
2 Type ID See (1) below for further information.
3 Firmware version See (2) below for further information.
b7 b0
0 0 1 0 0 0 0 1
Default value n:
Explanation (1) Type ID is fixed at 21H for this printer.
(2) The firmware version is updated as below every time firmware is upgraded or
revised:
A(41H) → B(42H) → C(43H) →････→ Z(5AH) → a(61H) → b(62H) → …
2-byte code supported
1, fixed (supported)
0, fixed
0, fixed
1 station
0, fixed (single)
Thermal printer
1, fixed (thermal)
To Next Page
Loading...
Need help?
General