CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-32
7.5.16 QR CODE MODEL SET COMMAND [GS] r
Function Sets the model of the QR code.
Format [GS] rn
Term n: Model to be set
1: Model 1
2: Model 2
Initial value n: 1 (Model 1)
Explanation (1) When “n” is set to any value other than the above, a command error occurs.
(2) This command is effective for the QR code only. If this command is set when
printing other barcode/two-dimensional codes, the command will be ignored.
Refer to Barcode/Two-Dimensional Code Print Command ([GS] k)
To Next Page
Loading...
Need help?
General