CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-120
5.6.9 TWO-DIMENSIONAL CODE FORMAT COMMAND (MicroPDF417) [ESC] XB
Format c [ESC] XBaa; bbbb, cccc, d, ee, ff, gg, h, iiii (= jjj ------ jjj) [LF] [NUL]
d [ESC] XBaa; bbbb, cccc, d, ee, ff, gg, h, iiii (; kk
1,
kk
2,
kk
3,
------ , kk
20
) [LF] [NUL]
Term aa: Two-dimensional code number
00 to 31
bbbb: X-coordinate of the print origin of the two-dimensional code
Fixed at 4 digits (in 0.1 mm units)
cccc: Y-coordinate of the print origin of the two-dimensional code
4 or 5 digits (in 0.1 mm units)
d: Type of two-dimensional code
X: MicroPDF417
ee: Security level
00: Fixed
ff: 1-module width
01 to 10 (in units of dots)
gg: No. of columns/rows
00 to 38
h: Rotational angle of two-dimensional code
0: 0°
1: 90°
2: 180°
3: 270°
iiii: Bar height
0000 to 0100 (in 0.1 mm units)
jjj-----jjj: Data string to be printed (Omissible)
Max. 366 digits
* The maximum of 366 digits of data string to be printed are acceptable. (The maximum number of
digits of the data string to be printed differs depending on the numbers of columns, the number of
rows, and the contents of data.) However, note the following limits:
• The maximum of 366-digit data string to be printed are acceptable. However, it cannot actually be
printed, since it cannot be contained within the 2-inch head width.
• If the print ratio of one line (the print head width) is high, printing may become poor, or the printer
may be reset. Be careful about the print ratio.
To Next Page
Loading...
Need help?
General