CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-28
4.3.2 LABEL ISSUE OPERATION
NOTES: (1) In the batch issue mode, the printer issues the designated number of labels. If
the labels are short because one failed to attach, issue labels again by pressing
the [FEED] switch (according to the parameter in the Data Print Command).
(2) If the B-SP series compatible mode is validly set with key operations in the strip
issue mode, the printer issues only one label in spite of the designation. Issue
the required number of labels by pressing the [FEED] switch.
(*) For the details of the B-SP series compatible mode, see the Key Operation
Specifications.
Printer
Start
To the next command
OK
Strip
Data is received.
< Data is checked. >
< Batch/Strip issue >
NG
Batch
Printing Printing
The status of
issue end is sent.
Press the
[FEED] switch.
The status of
issue end is sent.
< Completion >
Yes
No
No
Yes
Yes
Is the [FEED]
switch pressed?
Printing Printing
Host
Start
Data Print Command
< Normal end >
No
To Next Page
Loading...
Need help?
General