CHAPTER 16 BARCODE/TWO-DIMENSIONAL CODE TABLE
B-EP Series
16-20
16.15.1 When the MaxiCode specification is set to “TYPE1: Compatible with the current version”
in the system mode:
c How to transmit the control code data
SOH (01H) → > A (3EH, 41H)
STX (02H) → > B (3EH, 42H)
Ú
GS (1DH) → > ] (3EH, 5DH)
RS (1EH) → > ^ (3EH, 5EH)
US (1FH) → > _ (3EH, 5FH)
d How to transmit the special codes
> (3EH) → > 0 (3EH, 30H)
e How to transmit the Kanji codes
• Shift JIS
• JIS hexadecimal
(For details, refer to the section for the Barcode Data Command.)
NOTE: “NUL” code in the table cannot be used; however, it can be designated. If it is designated,
data following “NUL” code is not printed.
To Next Page
Loading...
Need help?
General