CHAPTER 11 OTHER FUNCTIONS
B-EP Series
11-10
11.11.3 DETAIL STATUS
[The compatible mode for the B-SP series is off.]
* The values in the upper cell are provided for LABEL/RECEIPT mode (1 byte HEX).
The values in the lower cell are provided for TPCL mode (2 bytes ASCII).
Detail Status
No.
LCD Message of the
Upper Line
(English)
Printer Status
Auto Status
Transmission
Status Request
Command
00H
ON LINE
The printer is in the online mode.
“00”
0BH
ON LINE
The printer is in the online mode (or
communicating).
“02”
0FH
LBL PRESENT ****
A label is waiting to be stripped.
“05”
10H
*1
ON LINE
A label issue has been completed normally.
“40”
ON LINE
A feed has been completed normally.
“41”
ON LINE
A head broken dots check has been completed
normally.
00
10H
1
ON LINE
Initialization has been completed normally.
01H
2
COVER OPEN
The front cover was opened in the online mode.
“01”
14H
3
PAUSE ****
The printer is in a pause state.
“04”
0CH 0CH
4
COMMS ERROR
A parity error, overrun error, or framing error has
occurred during communication through the RS-
232C interface.
03H 03H
5
PAPER JAM ****
A paper jam has occurred during a paper feed.
“11” “11”
04H 04H
6
NO PAPER ****
The paper has run out.
“13” “13”
0DH 0DH
7
NO PAPER
A label has been completed normally, and then the
paper has run out.
“09” “09”
05H 05H
8
COVER OPEN ****
An attempt was made to feed or issue with the
cover opened (except the [PAUSE] key).
“15” “15”
06H 06H
9
HEAD ERROR
A broken element has been found on the thermal
head.
“17” “17”
07H 07H
10
EXCESS HEAD TEMP
The print head temperature has exceeded 71 °C.
“18” “18”
55H
11
SAVING #### &&&&
The printer is in writable character or PC command
save mode.
“55”
09H 09H
12
FORMAT ERROR
An erase error has occurred in formatting the flash
memory.
“51” “51”
08H 08H
13
FLASH WRITE ERR.
An error has occurred in writing data into the flash
memory.
“50” “50”
To Next Page
Loading...
Need help?
General