CHAPTER 2 OUTLINE OF SPECIFICATIONS
B-EP Series
2-1
2. OUTLINE OF SPECIFICATIONS
2.1 GENERAL DESCRIPTION
This chapter describes the outline of specifications – modes, which the printer has. For more details,
refer to the appropriate chapter.
[TPCL (TEC Printer Command Language) mode]
The printer draws data according to the format information and print data sent from the host, and
issues labels according to the Issue Command.
[LABEL mode]
The label format information, graphic data, or writable character data sent from the host, is
previously stored in flash ROM as an initial setting. The printer links the print data sent through its
interface to the format data or writable character data in flash ROM, then draws and issues.
[RECEIPT mode]
The printer draws and issues according to the data or commands sent from the host.
[ESC/POS mode]
The printer draws and issues according to the data or commands sent from the host.
[SYSTEM mode]
In this mode, self-test printing, slant line printing and settings/changing of internal parameters are
performed.
To Next Page
Loading...
Need help?
General