CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-2
7.2 OUTLINE OF COMMANDS
7.2.1 FORMAT OF INTERFACE COMMAND
ESC Command
GS Command
ESC Command LF NUL
FF
CAN
The control codes are as follows:
y ESC (1BH)
y LF (0AH)
y NUL (00H)
y GS (1DH)
y FF (0CH)
y CAN (18H)
7.2.2 HOW TO USE REFERENCE
Function Describes the outline of the function of the command.
Format Shows the format of the command
The format designation method should conform to the following rules:
• “n” indicates a parameter item.
• Brackets and parentheses are used only in coding, and must not be
transmitted in practice.
• Other symbols must always be inserted at the designated positions before
being transmitted.
Term Explains the term(s) used in the format.
Initial value Indicates the initial value of the parameter (when turning the power on, or
changing the print mode to the RECEIPT mode.)
Explanation Explains the command in detail.
Refer to Related commands