CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-174
5.10.2 BIT MAP WRITABLE CHARACTER COMMAND [ESC] XD
Function Stores writable characters and logos in the flash ROM on the CPU board.
Format [ESC] XD; (Sj, ) aa, b, ccc, ddd, eee, fff, ggg, h, iii ----- iii [LF] [NUL]
Term Sj: Reserved area (Omissible)
j: 0 to 2
aa: Writable character set
01 to 40
41 16 × 16 (dots)
42 24 × 24 (dots)
43 32 x 32 (dots)
51 2-byte code character
52 to 55 Reserved
b(b): Writable character code
20H to FFH (Set in hex.)
40H to 7EH, 80H to FCH (When the writable character set is 41 to 43)
2020H to FFFFH (When the writable character set is 51)
ccc: Left offset
000 to 719 (in units of dots)
ddd: Top offset
000 to 719 (in units of dots)
eee: Character width
001 to 720 (in units of dots)
fff: Character height
001 to 720 (in units of dots)
ggg: Character-to-character spacing/proportional spacing
000 to 999 (in units of dots)
h: Type of writable character data
0: Nibble mode (4 bits/byte)
1: Hex. mode (8 bits/byte)
iii ----- iii: Writable character data to be stored
* When the writable character type is 41 to 43, left offset, top offset, character width,
character height, and character-to-character spacing/proportional spacing are fixed at
“000.” Any settings are ignored.
To Next Page
Loading...
Need help?
General