CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-7
10.7 COMMANDS RELATED TO FINE ADJUSTMENT
10.7.1 PRINT START POSITION FINE ADJUST COMMAND [ESC] AX
Function Adjusts the feed value so that the label will be shifted forward or backward from the
print start position automatically determined.
Format [ESC] AX; abbb, cddd, eff(, g) [LF] [NUL]
Term a: Indicates the direction, forward or backward, in which a fine adjustment is to be
made.
+: Backward
-: Forward
bbb: Fine adjustment value for print position
000 to 500 (in 0.1 mm units)
c: Indicates the direction of the strip position, forward or backward.
+: Backward
-: Forward
ddd: Fine adjustment value for strip position
000 to 030
* In - (Forward) a fine adjustment is to be made between 000 and 020.
e: Reserved area
Fixed at +.
ff: Reserved area
Fixed at 00.
g: Reserved area (Omissible)
hhh: Reserved area (Omissible)
[In compatible mode for the B-SP series]
a: Indicates the direction, forward or backward, in which a fine adjustment is to be
made.
+: Backward
-: Forward
bbb: Fine adjustment value for print position
000 to 500 (in 0.1 mm units)
c: Reserved area
Fixed at +.
ddd: Reserved area
Fixed at 000.
e: Reserved area
Fixed at +.
ff: Reserved area
Fixed at 00.
g: Reserved area (Omissible)
hhh: Reserved area (Omissible)