Toshiba B-EP4DL-GH32-QM-R - Page 647

CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-8
Explanation (1) When any value other than + or – is designated for the backward/forward print
position fine adjustment, a command error results.
(2) When any fine adjustment value for print position which is out of the above range,
is set, an error results.
(3) A range check is not carried out for the reserved areas. However, only numerals
can be used.
(4) The fine adjustment value is a sum of the value set using this command and the
value set in the SYSTEM mode (through printer key operations). However, the
maximum value is ±50.0 mm. When the sum exceeds ±50.0 mm, the value is
corrected to ±50.0 mm when printing is performed.
(5) The fine adjustment value for strip position is valid only when “the compatible mode
for the B-SP series” is turned off in the SYSTEM mode. When the parameter “a”
is set to any value other than “+” or “-,“ a command error occurs. When the
“compatible mode for the B-SP series” is turned on, the value is ignored.
[Print position (feed amount) fine adjustment] (to shift the label backward or forward)
0.0mm
+3.0mm
-3.0mm

Label
Print start position
Label
Print start position
Label
Print start position
Paper feed direction