CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-5
(2) Where the Saved Data Read Command is used:
NOTES: (1) The Feed Command can be omitted if the same sheet is used before Power OFF
and after Power ON.
(2) The Saved Data Read Command can be omitted after the power is turned OFF
and then ON if the command is set as [Automatic read after Power ON: Enabled].
(3) When XML data is used:
The XML format can be used for transmitting print data to the printer.
(*) For details, see the XML Specifications.
Bit Map Font Data Command
<Changed data issue>
Yes
Place paper
Saved Data Read Command
[ESC] XQ: Reads the label format stored in flash
memory.
[ESC] RC: Draws bit map font data.
Feed Command
[ESC] T: Feeds one sheet of paper and aligns it
with the first print position.
Outline Font Data Command
[ESC] RV: Draws outline font data.
Barcode/2-D Code Data Command
[ESC] RB: Draws barcode/2-D code data.
Issue Command
[ESC] XS: Issues (prints) the label.
No
<Label change>
Yes
No
Power OFF
Power ON or
To Next Page
Loading...
Need help?
General