CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-16
4.2.3.3 GRAPHIC COMMAND
When transmission is cancelled while graphic data is transmitted from the application, the data
cannot be properly printed because data subsequently transmitted is recognized as a graphic
command unless the graphic data has been transmitted before the transmission is cancelled.
If communication is interrupted while graphic data is transmitted, it is necessary to transmit
graphic data for the number of bytes that was not transmitted as dummy data, turn off and on the
power of the printer, or reset the printer.
[Command transmission and print results (Examples)]
* Descriptions are provided without graphic data omitted.
(1) When transmitting print data for two labels as usual,
{D0821,0458,0801|}
{C|}
{SG;0161,0339,0096,0300,2,BM[D6][10][00][00][00] 1st label data
[FF][FF][FF][FF][FF][FF]|}
{XS;I,0001,0000C2001|}
{D0821,0458,0801|}
{C|}
{SG;0161,0339,0096,0300,2,BM[D6][10][00][00][00] 2nd label data
[FF][FF][FF][FF][FF][FF]|}
{XS;I,0001,0000C2001|}
Print result: The 1st label data and 2nd label data are printed in a row.
To Next Page
Loading...
Need help?
General