CHAPTER 4 TRANSMISSION SEQUENCE
B-EP Series
4-55
NOTES: (1) In the ESC/POS mode, the status of issue end is not automatically sent. Before
the next receipt is issued, whether or not the sent data is issued normally should
be confirmed by sending the Status Request Command. When a receipt is not
issued due to an error, the data should be sent again.
(2) In the ESC/POS mode, when the [FEED] switch is pressed, a 20-mm feed is
performed.
(3) In the ESC/POS mode, the issue count cannot be set. If the batch/strip issue
mode is set, it does not become effective.
To Next Page
Loading...
Need help?
General