CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-58
(12) Italic designation
This designation allows italic printing. However, it is available only when TEC FONT1 is
selected for the type of font.
(13) Character string width and number of character string digits
Usually, one character size is determined by the character width and height. When the
character string width and number of character string digits are specified, the character
width will be automatically changed when printed. If the following conditions are satisfied,
however, these parameter settings become ineffective, and the characters are printed in
normal size.
• Conditions of ineffectiveness
(1) These parameters are omitted.
(2) The character string width is set to “0”.
(3) No. of print data ≥ No. of specified character string digits
• Conditions that these parameters become effective are described on the following
pages.
To Next Page
Loading...
