CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-165
d Top first printing
(4) Status response
When “Status response is returned.” is selected, a status response is returned at the end
of printing or if an error occurs.
In the batch mode, the print end status response is returned after the designated number
of labels is printed.
In the strip mode, a status response is returned after one label is printed.
* Do not change the setting of the status response parameter during printing.
Otherwise the status response may not be returned properly.
(5) Reserved area (Omissible)
The described values should be designated to d, e, and f. When any value from 0 to 3 is
designated to g, a command error does not occur. However, any value other than 1
should not be designated because it is fixed at 1.
Black mark
(Back side of paper)
Effective
print length
Effective
print width
Tag
pitch
Tag
Paper feed direction
0
X
Y
Effective
print length
Origin of
coordinates
(0, 0)
Label
Backing paper
Effective
print width
Label
pitch
Paper feed direction
0
X
Y
Origin of
coordinates
(0, 0)
[Label] [Tag]
To Next Page
Loading...
Need help?
General