CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-6
(10) When changing the print mode by the printer itself, the print position detection feed
parameter cannot be set.
(11) When the mode select command is designated with the print position detection
feed at the end of a print data issued in RECEIPT1 or ESC/POS mode, and if an
error occurs while printing, the printing will restart after the error is cleared and
then, the print mode will be changed to the LABEL or TPCL mode and a print
position detection feed is performed. When the print position detection feed
setting is omitted, the mode is not changed to LABEL or TPCL (the mode select
command is discarded).
(12) When the LABEL or TPCL mode is selected in the mode select command and the
print position detection feed parameter is set 0 (not performed), and if an error
occurs while the printer issues in RECEIPT1 or ESC/POS mode, the print mode is
changed to the LABEL or TPCL mode after the error is cleared. (The mode select
command is executed.)
To Next Page
Loading...
Need help?
General