CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-46
Printer status ......... Printer status is indicated in 2-byte data.
“00”: Normal status
“01”: Cover open state
“02”: Operating
“04”: Pause state
“05”: Wait for strip
“06”: Command syntax error (including Ir packet error)
“09”: Normal issue end + Label end
“11”: Paper jam
“13”: Label end
“15”: Cover open error
“17”: Broken thermal print head dots
“18”: Thermal head excessive temperature
“19”: Ambient temperature error
“32”: Abnormal battery temperature
“33”: Battery excessive temperature
“36”: Low battery
“37”: Charging error
“39”: Bluetooth setup error (including initialization error)
“45”: Wait for battery recovery
“46”: Wait for print head temperature reduction
“47”: Wait for motor temperature reduction
“50”: Flash ROM write error
“51”: Flash ROM erase error
“54”: Flash ROM storage area full state
“55”: Writable character/PC command save mode
Remaining No. of labels ...... Indicates the remaining number of labels in four bytes.
“0000” to “9999”
Length: .................. Indicates the number of bytes of the entire status data
IrDA: TEC Protocol: Fixed at “22.”
IrDA: IrCOMM, IrDA: IrOBEX, USB,
RS-232C, Bluetooth, Wireless LAN: Fixed at “23.”
Receive buffer free space: .... Indicates the free space of the receive buffer.
Entire receive buffer free space: .... Indicates the entire free space of the receive buffer.
Fixed at “00512.”
CRC/CR, LF: ......... Indicates the end of the status block.
To Next Page
Loading...
Need help?
General