CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-86
(6) The print mode can be changed by the printer itself. However, since the setting for the
automatic status response in IrDA: IrCOMM or USB cannot be changed, the setting
remains as the same.
(7) As the print position detection feed parameter is effective only when changing the print
mode to LABEL or TPCL, this parameter status will be ignored when changing the mode to
RECEIPT, RECEPT1 or ESC/POS.
(8) The print position detection feed is performed according to the conditions, such as, label
pitch, fine adjustment, and sensor selection, which were set in the LABEL or TPCL mode
before the printer is operated in the RECEIPT, RECEIPT1 or ESC/POS mode. If no
sensor is selected, the print position detection feed will not be performed.
(9) After performing a print position detection feed, the printer does not send a process end
status. If an error occurs during the print position detection feed, the print position
detection feed is performed after the error is cleared by using the PAUSE key (when the
key operation or Set Command ([ESC] ZM03) is used to enable the print position detection
feed setting after closing the cover.)
(10) When changing the print mode by the printer itself, the print position detection feed
parameter cannot be set.
(11) When the mode select command is designated with the print position detection feed at the
end of a print data issued in the RECEIPT1 or ESC/POS mode, and if an error occurs
while printing, the printing will restart after the error is cleared and then, the print mode will
be changed to the LABEL or TPCL mode and a print position detection feed is performed.
When the print position detection feed is omitted, the print mode will not be changed to the
LABEL or TPCL mode. (The mode select command is discarded.)
(12) When the LABEL or TPCL mode is selected in the mode select command and the print
position detection feed parameter is set 0 (not performed), and if an error occurs while the
printer issues in the RECEIPT1 or ESC/POS mode, the print mode is changed to the
LABEL or TPCL mode after the error is cleared. (The mode select command is
executed.)
To Next Page
Loading...
Need help?
General