CHAPTER 3 INTERFACE
B-EP Series
3-58
d LABEL mode (Issue)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
STX Printer ID Printer status Battery level
02H xxHxxH 00H
xxH
Make sure that the printer is
in idle state.
c Request for a Bluetooth
connection
c Response to the request for a Bluetooth
connection
d Status sent in response to the status
request command.
Host Printer
fRequest for a disconnection
of the Bluetooth connection
fResponse to the request for the
disconnection of the Bluetooth connection
e Status indicating a normal termination of a label
issue
Normal termination
A status request
command does not
need to be sent.
STX Printer ID Printer status Battery level
02H xxHxxH 10H
xxH
[ESC]X01H01H01H. . .
[LF][NUL]
e Data print command
01H: Transmissive sensor
11H: Reflective sensor
21H: No sensor
Note: Automatic status
transmission is enabled.
Issue
Waiting time
until the end
of a print job
d Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior to
a data transmission.)
To Next Page
Loading...
Need help?
General