CHAPTER 3 INTERFACE
B-EP Series
3-67
g TPCL mode (Storing writable characters, PC save)
* The printer status can also be confirmed with the following command:
• [ESC] WB [LF] [NUL]
Note that the contents of the status vary, which deserves special attention.
Min. 100msec.
SOH STX Status Unprinted count ETX EOT CR LF
01H 02H 30H30H
xxH 3xH3xH3xH3xH 03H 04H 0DH 0AH
Provide 100 msec. or more wait
time after the termination of data
transmission via Bluetooth.
- [ESC]XD . . . [LF][NUL]
- [ESC]XO . . . [LF][NUL]
to [ESC]XP[LF][NUL]
Make sure that the printer is in
idle state.
eBit map writable character
command or Save start
command
d Status sent in response to the status
request command.
Data
storage
Confirmation
of the printer
status prior
to data
storage
One of the following
commands:
- [ESC]FM[LF][NUL]
- [ESC]WS[LF][NUL]
- [ESC]v
c Request for a Bluetooth
connection
c Response to the request for a Bluetooth
connection
Host Printer
fRequest for a disconnection
of the Bluetooth connection
fResponse to the request for the disconnection
of the Bluetooth connection
d Status request command
(Usually, a status request
command is not necessary to be
sent. However, send this
command when the printer status
is required to be confirmed prior
to a data transmission.)
To Next Page
Loading...
Need help?
General