USTER HVI 900 - Samples; Test Status Box; Message Box

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 6
Version 4.0 (1.99) HVI 900 System Testing - Page 6-11
5.12 Samples
This is the number of samples tested since the sample counter was reset
on the S
IGN-ON MENU. The number increments after all the tests have
been completed and the data are sent to the printer or the external
computer system.
5.13 Test Status Box
The box at the bottom left of the screen contains the number of
repetitions to be performed for each module listed. The first number is
the number of repetitions that have been performed for the sample. The
second number is the number of repetitions that was designated on the
STATUS MENU TO be performed for the sample.
5.14 Message Box
The box at the bottom left of the screen displays messages that involve
the external computer system, retests, lot limits, rejecting sample test
results, and leaving the System Testing mode. The current Calibration
Mode (ICC or HVI) is displayed in the message box header. The
messages displayed in this box vary when the ESCAPE key is pressed
depending on whether the test results are sent to a printer, or to the
printer and external computer (refer to the section, How to Exit from
System Testing, in this chapter).