USTER HVI 900 - Keyboard Commands; Exit from Operation; Changing Selections;Parameters

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 1
Version 4.0 (1.99) Introduction - Page 1-7
6 Keyboard Commands
Pressing the ENTER key on the keyboard registers an entry into the
computer. An entry can be erased any time before pressing this key
and corrected using the backspace key.
If the keyboard does not respond to input or if the system halts in mid-
operation, reset the system (refer to Resetting the HVI 900 System in
Chapter 3). If there is still no response, turn off the main power switch
located on the front of the Length/Strength cover.
6.4 Exit From Operation
Occasionally, you may wish to escape an operation without completing
the sequence. Generally, pressing the ESCAPE key can do this.
6.5 Changing Selections/Parameters
Selections are made and parameters changed depending on specific
screens. Use the appropriate method below to change parameter
options and/or make selections.
• If an arrow appears to the right side of an item, this indicates
that this selection accesses a submenu. When you press ENTER
in such cases, the submenu will display the items pertaining to
that selection.
• If an item contains alternative choices, the ENTER key can be
used to move the cursor from choice to choice. Each press of the
ENTER key will display the next choice. To return to the original
choice, press ENTER continuously until the screen displays the
initial information. The choices are displayed in a looping-type
sequence; stop when the one you want is displayed.