USTER HVI 900 - Synthetic Fiber Standard Values; Synthetic Fiber Calibration Constants; Synthetic Fiber Calibration Tolerances

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 10
Version 4.0 (1.99) Synthetic Fiber Testing - Page 10-20
4.6 Synthetic Fiber Standard Values
This menu item is used to enter the standard Fiber Length, Fiber
Uniformity, Fiber Strength, and Fiber Elongation.
•
Change the values using the same procedure that is used to change
the Fiber Dependent Instrument Constants.
4.7 Synthetic Fiber Calibration
Constants
This menu is used to enter the values for Length Slope and Offset,
Uniformity Slope and Offset, Strength Slope and Offset, and Elongation
Slope and Offset.
• Change the values using the same procedure that is used to change
the Fiber Dependent Instrument Constants.
4.8 Synthetic Fiber Calibration
Tolerances
This menu is used to enter the tolerance values for Length, Uniformity,
Strength, and Elongation.
• Change the values using the same procedure that is used to change
the Fiber Dependent Instrument Constants.