USTER HVI 900 - Chapter 7 Module Testing; Module Testing Menu

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-1
Chapter 7 Module Testing
3 Module Testing Menu
The purpose of Module Testing is to test individual samples outside the
normal System Testing sequence. Module Testing can be performed for
Length/Strength, Micronaire, and Color/Trash. Because each test is
performed independently from the other modules, only the data for the
selected module are collected and reported (with the exception that
micronaire may be tested during Length/Strength Module Testing).
• To access the MODULE MENU from the MAIN MENU highlight Module
Testing and press ENTER.
The main difference between System Testing and Module Testing is the
way the test results are reported; Module Testing produces individual
results whereas System Testing produces an average of all test results.
The procedures for Module Testing are essentially the same as in System
Testing.