USTER HVI 900 - Status Listing

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 4
Version 4.0 (1.99) Status - Page 4-32
4.22 Status Listing
The Status Listing item maintains a list of all the software values,
including calibration standard values, offsets, lot limits, system constants,
motor constants, correction constants, calibration constants, etc.
Two types of reports can be generated to list this data. When Status
Listing is selected, a window is displayed. The Operator Listing, the
most commonly printed report, can be printed to display useful setting
data. It should be printed after initial installation and after any software
updates.
The Service Listing is typically used by Uster Technologies, Inc. Service
Technicians to help troubleshoot any problems that you may be
experiencing.
Once you select the type of report to be generated, press ENTER. A
window will display that allows you to generate the report to a file or to
the printer.
• When File is selected, an entry box is displayed requesting that a
filename be entered. The filename can be up to eight (8) alpha
characters. Enter a filename that you will remember, and press