USTER HVI 900 - Okidata 520 Printer

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 14
Version 4.0 (1.99) Appendix - Page 14-7
6.5 Okidata 520 Printer
The Okidata 520 is a parallel printer. If a serial printer is required for
your application, a serial card is available from Okidata upon request.
In order for the Okidata 520 printer to communicate with the HVI, the
following changes have been made to the printer software selections at
the Uster Technologies factory.
Printer Control/Emulation Mode EPSON FX
Font Pitch 12 CPI
Character Set Set II
•
To check and/or change the printer selections, check to ensure
paper is loaded in the printer. Turn on the printer power. Press the
SHIFT and SEL keys on the left side of the printer keypad. The
menu will be illuminated. Press the PRINT key.
The current setup will print. Check the printout to see if the current
configuration is set to “EPSON FX.”
• If it is not Press the GROUP key to move to the “Printer Control/
Emulation Mode” line if you are not in the Printer Control group.
As you press the keys, the printer will print the current line.
• Once in the Printer Control group, press the SET key until the Mode
is set to “EPSON FX.”
Check the printout to see if Font is set to “12 CPI.”
•
If it is not, press the GROUP key to move to the “Font” group. Press
ITEM to move to the Font Pitch line. Press the SET key until the Font
Pitch is set to “12 CPI.” Check the printout to see if Character Set is
set to “Set II.”
• If it is not, press the GROUP key to move to the “Symbol Sets/
Character Set” group. Press the SET key until the Character Set is
set to “Set II."