USTER®
HVI 900
Instruction Manual
Uster Technologies, Inc.
Chapter 5
Version 4.0 (1.99) Calibration - Page 5-14
4.8 Length Units
This selection alternates between English (inches) and Metric
(millimeters).
♦ English — The reporting units are in inches.
♦ Metric — The reporting units are in millimeters.
The software automatically changes the regression coefficient length
value for the Length Units selected.
•
Change the option by using the arrow keys to highlight the item,
then by pressing the ENTER key to toggle between options. Press
ESCAPE to save the change.
Note: It is not necessary to calibrate after changing the length units.
The instrument makes all necessary conversions.
4.9 ICC SL1%
The cotton industry has chosen 50 percent for the ICC mode. When this
item is selected, an instruction line is displayed on the screen asking you
to enter a value for ICC SL1 %. You may enter a value other than 50
percent, if desired.
When the Calibration Mode is set to HVI, no information is displayed in
this field. A warning message is displayed indicating that Calibration
Mode must be changed to ICC to set ICC SL1%.
• Change the values, if needed, by using the arrow keys to highlight
the item, then by pressing the ENTER key. Enter the value at the
prompt and then press ESCAPE to save the data.
To Next Page
Loading...
