USTER HVI 900 - Selecting the Identifier(S) to Appear on the Report

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 8
Version 4.0 (1.99) 940 DataManager - Page 8-9
4.6 Selecting the Identifier(s) to
Appear on the Report
Reports are generated by the sample Identifier.
• When you highlight Identifier and press ENTER, the Identifier
window is displayed with all the identifiers that are stored in 940
DataManager.
The identifiers for the most recently completed tests are listed first
(reverse chronological order). The current page number and the total
number of pages are displayed in the upper right corner of the window
(e.g., Page 1 of 6). The first number is the number of the page that is
currently displayed and second number is the total number of pages
(screens) that are required to display all the identifiers. Use the Page
Up and Page Down keys to view the different pages (screens) of
identifiers.
When multiple identifiers are on the list, the last entry will be " All
Identifiers ." When it is selected, the entire list of identifiers will be
included in the report.
• Select the Identifier(s) that should be included in the report (up to 10)
using the arrow keys to highlight the item, then press the ENTER
key. An arrow points to the identifier when it is selected. De-select
an Identifier by pressing the ENTER key again to remove the arrow.
•
When you have completed the selection of identifier(s), press
ESCAPE to save the information and return to the R
EPORT MENU.