USTER HVI 900 - Identifier; Reset Sample Counter; System Testing

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 6
Version 4.0 (1.99) HVI 900 System Testing - Page 6-6
4.5 Identifier
This is a system-required field when test results are to be sent to a printer
or an external computer. You cannot proceed with the
Continue with
Testing until you have entered information in this field. An entry box is
displayed where up to 30 alphanumeric characters can be entered.
This identifying information can define the lot or merchant for a
particular group of samples. Generally, each lot should have a specific
identifier assigned. If you are using the 940 DataManager, the Data
File Name should be the same as the first eight (8) characters of the
Identifier (refer to Chapter 8, 940 DataManager, for further
information).
Once the Identifier has been entered, it remains the same for both
System Testing and Module Testing until you exit the testing mode.
4.6 Reset Sample Counter
The Sample Counter tracks the number of tests that have been
performed by the instrument since the sample counter was last reset.
When this item is selected, the counter automatically resets to zero (0).
The sample counter should be reset during initial startup.
5 System Testing
•
To access the System Testing screen from the SIGN-ON MENU,
highlight Proceed with Testing and press ENTER.
The large letters on the test display screen enable the operator to quickly
read all the essential information. The data required for the information
fields on the System Testing screen depend on the way the system was
set up using the STATUS MENU (see Chapter 4).