USTER HVI 900 - Entering Parameter Information

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 4
Version 4.0 (1.99) Status - Page 4-2
3 Entering Parameter
Information
Each menu item on the S
TATUS MENU will display either the option
currently selected or an arrow indicating that another menu can be
accessed to display the parameter options. Each of the parameter
options can be changed using any of the following methods.
• If an arrow appears to the right side of an item, this indicates that
this selection accesses a submenu. When you press ENTER in such
cases, the submenu will display the items pertaining to that selection.
• If an item contains alternative choices, the ENTER key can be used
to move among the choices. Each press of the ENTER key will
display a new choice. To see each one, press ENTER until the
screen repeats the initial information. The choices are displayed in a
looping-type sequence.
• When an item requires that free-form information (values) be
entered, an entry box displays when you press ENTER. Type the
new value(s) in the entry box using the keyboard.
Check the accuracy when you enter information using the keyboard
before pressing ENTER. If a typo is made, it can only be corrected by
pressing the backspace key before pressing the ENTER key. The
characters are removed one at a time.
• Press the ESCAPE key to save the options and return to the Main
Menu once the S
TATUS MENU reflects your choices.
Note: The menus and screens you see displayed may be different
from those in this manual depending on the selections made on the
Status Menu. This manual reflects screen captures taken from an HVI
900 system with the Length/ Strength, Micronaire, and Color/Trash
Modules using version 4.0 Software. Your monitor may have certain
menu items dimmed. If so, the dimmed items are not pertinent to your
software configuration.