USTER HVI 900 - Limits to Selecting Properties; Selecting the Type of Report

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 8
Version 4.0 (1.99) 940 DataManager - Page 8-12
4.8 Limits to Selecting Properties
If the report is to be displayed on the screen as opposed to being
printed, the size of the screen limits the number of properties that can be
displayed on one line (maximum of 79 characters).
A report that is printed is limited to 131 characters per line. If the
number of characters for your selections exceeds 131, a warning
message is displayed on the screen. Divide the report into two sections
if the report must contain more information than will fit on the report
according to your report specifications—use the same specifications, but
divide the properties between the two reports.
4.9 Selecting the Type of Report
Reports can be displayed or printed in three different ways:
• Value—The test values from the HVI are reported for samples in
each identifier for the properties selected.
• Categories—The test values are assigned to a category according
to the category definitions specified in the STATUS MENU. The
assigned category is displayed/printed on the report.
•
Values/Categories—Both the test values and the assigned
category number are displayed/printed.
Access the REPORT TYPE screen by highlighting the Report Type item, then
pressing ENTER.