USTER HVI 900 - Grade Entry

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 4
Version 4.0 (1.99) Status - Page 4-4
Highlight each item that applies by using the arrow keys and pressing
the ENTER key. An arrow is displayed to the left of each selected
choice. Test results can be sent to multiple locations. For example, if
you want the test results to be sent to both a printer and to the 940
DataManager, highlight Printer , and press ENTER. Then, highlight
DataManager , and press ENTER again. Arrows will be displayed
beside both the Printer and DataManager items. Press ESCAPE to save
the settings and return to the STATUS MENU.
• Select a single item by highlighting it in the list using the arrow keys,
then press the ENTER key. This will remove the arrow displayed to
the left of the item. Press ESCAPE to save the settings and return to
the STATUS MENU.
• Select all items by highlighting None , then pressing the ENTER key.
The arrow will be removed from all the selections and be positioned
by None . Press ESCAPE to save the settings and return to the
STATUS MENU.
4.5 Grade Entry
The Grade Entry option can be turned Off or On. When Grade Entry is
turned ON, it is required that a cotton grade value be entered by the
operator for each sample test.
♦ Off — The cursor will not stop on the Grade field during System
Testing.
♦ On — The cursor will stop in the Grade field during System Testing
where the operator should enter up to six (6) alphanumeric
characters using the keyboard. This can be a grade code or
other information that should be stored about the sample.
There is not a Grade field in Module Testing.