USTER HVI 900 - System Testing; Module Testing

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 3
Version 4.0 (1.99) System Startup - Page 4
4.4 System Testing
This selection is used during normal system testing of fibers and is the
default selection for this menu. It is selected simply by pressing the
ENTER key after highlighting
System Testing . The SIGN-ON MENU will
be displayed. The following selections are available from the SIGN-ON
MENU.
♦ Proceed with Testing
♦ Identifier
♦ Reset the Sample Counter
Refer to Chapter 6, HVI 900 System Testing, for detailed information on
the system testing procedures used for an HVI 900 system.
4.5 Module Testing
Module Testing should be used when only one of the Modules in the
HVI system is required for testing. It is selected by highlighting MODULE
TESTING and pressing the ENTER key. The MODULE TESTING MENU will
be displayed. The MODULE TESTING MENU can include any of the
following selections depending on the modules installed in your system.
♦ Length & Strength
♦ Micronaire
♦ Color & Trash
Refer to Chapter 7, Module Testing, for detailed information on the
using these menu items.