USTER HVI 900 - Number of Length;Strength Tests (10 Max); Color Grade

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 4
Version 4.0 (1.99) Status - Page 4-7
4.12 Number of Length/Strength Tests
(10 max)
This item is used to indicate the number of length and strength tests that
are to be performed on each sample. Enter the amount using the
number keypad, then press ENTER. It is recommended that two (2)
Length/Strength Tests be performed. If no tests should be performed, set
the number to zero (0).
Note: If you enter a number greater than the maximum (10), an error
message will be displayed. Press
ANY KEY to clear the error message
and then enter a valid number.
4.13 Color Grade
The Color Grade item is used to select the color grade chart to be used
during testing. Upon system installation, Upland and Pima are the only
choices of color grade. As additional charts are created, they will be
displayed as Color Grade options. Highlight the name of the chart to
be used and press ENTER.