USTER HVI 900 - Micronaire Testing Procedures

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 7
Version 4.0 (1.99) Module Testing - Page 7-20
The Micronaire Module Testing screen will appear. This screen differs
from the one used for System Testing in that the module testing screen
displays the results for each test, as well as the average of all the tests
for each sample.
If test results will be sent to a printer or transmitted to a host computer,
an ID must be entered on the test screen. If the data will not be printed
or transmitted, no ID is requested.
Once the ID number (if required) has been entered, the instruction line
says “Test 1 of X.”
4.6 Micronaire Testing Procedures
•
If an ID is required (because the data will be printed or transmitted),
enter up to 12 alphanumeric characters for the bale identification
number via the keyboard or scanner. Be sure the number is entered
correctly, and then press ENTER.
• The highlighted instruction line will display "Test 1 of XX," with XX
being the total number of tests that are to be performed for each
sample.