USTER HVI 900 - Property

USTER® HVI 900 Instruction Manual
Uster Technologies, Inc. Chapter 8
Version 4.0 (1.99) 940 DataManager - Page 8-19
When multiple identifiers are on the list, the last entry will be " All
Identifiers ." When it is selected, the entire list of identifiers will be
included in the report.
• Select the Identifier(s) that should be included in the report (up to 10)
using the arrow keys to highlight the item, then press the ENTER
key. An arrow points to the identifier when it is selected. De-select
an Identifier by pressing the ENTER key again to remove the arrow.
• When you have completed the selection of identifier(s), press
ESCAPE to save the information and return to the R
EPORT MENU.
If you selected only one identifier, that identifier name is displayed to
the right of Identifier. If multiple identifiers are to be used for the Report,
an arrow is displayed on the Identifier line. If you selected
All
Identifiers, "All Identifiers" is displayed to the right of the Identifier field.
Note: If you select Make Histogram when no identifier has been
selected, a warning message window is displayed on the screen. You
must select an identifier(s) before you select Make Histogram.
5.6 Property
A window containing a list of all the fiber properties is displayed. Use
the Arrow keys to highlight the property to be plotted. The HISTOGRAM
MENU will appear and the property name will be displayed and remain
as the selection until it is changed.